Once the application program "SkyMedia200" has been successfully installed,
there should be a "sky200 data" icon in your task bar > From the image above you can see a red cross over the satellite,
which means the card isn’t configured correctly.
To configure the card you need to double click on this icon to access the data setup.
Once in the data setup you should have a screen as below:
 From the image above you can see the "Permanent Address"
also known as the "MAC Address" and the "IP Address".
Select "Satellite" to setup the settings for the skymedia card.
Once in "Satellite" you will have a screen as above where you need to click on "Add" then "New" to add a new satellite which should bring up the next screen.
Once in the "Add Satellite" screen you need to enter the name "Ultra" into the Satellite name sections. Fill in the other fields by refering to settings. Then click on "OK". GO TO NEXT PAGE >
|