Telemann Satellite Card Set Up > PAGE 2
You should now have a screen as above. You now need to click on "Add" in the Transponder List to add in a new transponder. This should bring up the following screen.
In the edit transponder screen add Down Link Frequency, Symbol Rate and Polarity (refer to settings). Then click on "OK". You should now have a screen as below.
From here you can now click on "Lock Test" to check to make sure the satellite is receiving a signal. A lock test should bring up the screen below.
From the image above we can see 4 smiling faces and an AGC value of "174" (AGC value will vary from 160 up to 190). The BER should usually come up as 0E-0 to indicate that there are no errors with the signal at all (this can jump up and down depending on different weather conditions). If the faces come up red then you need to go back and double check the information that you have entered in for the satellite. If the card comes up with the 4 green faces you should notice the cross over the "sky200 data" icon in the taskbar should disappear and should look like this > You can now click on "close".
GO TO NEXT PAGE >